skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Separating new conrod (Roomster)

Fabia Mk2

Removing and installing drive chain sprocket (Roomster)
Removing and installing drive chain sprocket (Roomster)
Special tools and workshop equipment required
t  Drive bushing -MP1-316 (30-100)-
t  Two-arm extractor
t  Protective gloves
Removing
–  Removing the oil pan → Chapter.
–  Remove the sealing flange on the belt pulley side → Chapter.
–  Remove drive chain sprocket for oil pump Pos. 19, chain tensioner Pos. 25 and chain Pos. 23 → Chapter.
   
–  Remove the drive chain sprocket with the two-arm extractor -2-, while protecting the shaft end of the crankshaft with a suitable washer -1-.
Install
Installation is performed in a similar way in the reverse order. Pay attention to the following points:
  WARNING
Wear protective gloves!
–  Heat up the drive chain sprocket in an oven for about 15 minutes to 220 °C.
–  Place the drive chain sprocket on the shaft end using pliers.
  A13-0058
–  Slide on the chain sprocket with bushing -MP1-316 (30-100)- until the stop on the crankshaft is reached.
l  Fitting location: The broad collar of the drive chain sprocket points towards the engine.
  A13-0059

Engine cylinder head, valve gear > < Separating new conrod (Roomster)