Skoda Workshop Service and Repair Manuals

Removing –  Remove air filter → Chapter. –  Unscrew vacuum regulating valve (PCV valve).

–  Detach vent line -1-. To do so press the securing ring. –  Disconnect ventilation hose -2- to the intake manifold at the activated charcoal filter. –  Remove activated charcoal filter and bracket. –  Remove the expansion reservoir and lay it to one side.    Coolant hoses remain connected. –  Remove the sound dampening system → Body Work; Rep. Gr.50. –  Remove the front right wheelhouse liner → Body Work; Rep. Gr.66. –  Remove V-ribbed belt → Chapter. On vehicles with air conditioning –  Remove AC compressor with the refrigerant lines connected from the bracket → Chapter.    Observe instructions for assembly work on the air-conditioning system → Chapter. –  Remove holder for tensioning device and V-ribbed belt-guide pulley On vehicles without air conditioning –  Remove ribbed V-belt tensioning device. Continued for all vehicles –  Remove alternator → Electrical System; Rep. Gr.27. –  Remove belt pulley for control pump → Chapter.

–  Remove crankshaft belt pulley.    Counterhold belt pulley with counterholder -T30004- with bolt -T30004/1-. –  Removing the oil pan → Chapter.

–  Fit supporting device -MP9-200 (10-222A)-. –  Raise engine slightly via spindle -B-, allow spindle -A- to hang loosely. On vehicles with assembly bracket version 1

–  Screw out screws -arrows- and remove engine mount. On vehicles with assembly bracket version 2

–  Unscrew nut -3- and disconnect earth lead from engine mount. –  Release screws -2 and 1- and remove engine mounting. For all vehicles

–  Release the Allen screws of the control unit and the screws marked with the -arrows-. –  Remove timing case.   Note Make sure that the bushing remains in the gasket ring of the timing case. –  Remove gasket of timing case.