–
| Position the flywheel lock -MP 1-504- on the starter ring gear and turn crankshaft until it rests against the bushing -T30010 -. |
–
| Release screws and remove flywheel. |
Installation is performed in the reverse order, pay attention to the following points: |
Note Use new screws for attaching. |
1.
| Tighten all the screws by hand. |
2.
| Tighten all the screws crosswise to 60 Nm. |
3.
| Torque all the screws crosswise a further 90° (1/4 turn). |
|
|
|