Fabia Mk2
1 - | Control for heating and air conditioning system |
q | with air conditioning system control unit -J301- |
t | is connected to other control units via CAN bus |
t | receives information about the heating and cooling output requirement and sends corresponding signals to the regulating valve for the compressor or the temperature flap positioning unit |
t | is checked by self-diagnosis → Vehicle diagnostic, testing and information system VAS 5051 |
2 - | Plug - air conditioning wiring loom |
3 - | Plug - vehicle wiring loom |
4 - | Flex shaft |
q | for positioning unit for air distribution flaps |
q | removing and installing → Chapter |
5 - | Switch for fresh air blower -E9- |
q | 4 speeds |
q | The air conditioning system is only activated when the fresh-air blower is switched on |
6 - | Rotary switch for air distribution flaps |
q | manual control of the flaps via the flex shaft, see Pos. 4 |
q | fresh-air operation is automatically activated (no misting up of windscreen) if „defrost“ is switched on during re-circulating air operation; return to re-circulating air operation by again pressing the re-circulating air button |
7 - | Dash panel temperature sensor -G56- |
q | with temperature sensor blower -V42- |
q | no longer fitted as of CW 46.2010 |
8 - | Switch for air conditioning system -E30- |
q | The air conditioning system is only activated when the fresh-air blower is switched on |
9 - | Switch for fresh air and re-circulating air flap -E159- |
10 - | Potentiometer for temperature selector -G267- |
q | Control of interior temperature from 16 to 31 °C |
q | turning the rotary switch to the left or right up to the stop deactivates the temperature control (temperature flap is fully open or fully closed) |
q | if the ambient temperature is higher than the set interior temperature, the air conditioning system must be activated. |