Fabia Mk2
| Summary of components of air conditioning unit |
| 1 - | Fresh air blower control unit -J126- |
| q | removing and installing → Chapter |
| 2 - | Air flow flap control motor -V71- |
| q | with installed potentiometer for air flow flap control motor -G113- |
| q | removing and installing → Chapter |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 3 - | Fresh air blower -V2- |
| q | removing and installing → Chapter |
| 4 - | Dust and pollen filter |
| q | also as combination filter with odour filter |
| q | removing and installing → Chapter |
| q | pay attention to change intervals → BookletRoomster |
| 5 - | Control motor of centre flap -V70- |
| q | with installed potentiometer for central flap control motor -G112- |
| q | removing and installing → Chapter |
| 6 - | Air conditioning system control |
| q | must be replaced completely |
| q | removing and installing → Chapter |
| 7 - | Plug for footwell vent temperature sender -G192- |
| 8 - | Footwell vent temperature sender -G192- |
| q | to disassemble, remove centre console → Body Work; Rep. gr.68, release plug and turn sender 90° to the left |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 9 - | O-ring |
| q | replace if damaged |
| 10 - | Heating element for air auxiliary heating -Z35- |
| q | only fitted on certain models |
| q | Summary of components → Chapter |
| q | removing and installing → Chapter |
| 11 - | Heat exchanger |
| q | Summary of components → Chapter |
| q | removing and installing → Chapter |
| 12 - | Control motor for temperature flap -V68- |
| q | with installed potentiometer for temperature flap control motor -G92- |
| q | removing and installing → Chapter |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 13 - | Defroster flap control motor -V107- |
| q | with installed potentiometer for defroster flap control motor -G135- |
| q | removing and installing → Chapter |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 14 - | Gasket with holder |
| q | clipped at heater unit |
| q | replace if damaged |
| q | Fitting position → Fig. |
| 15 - | Valve for condensation water drain |
| q | mount together with holder -Pos. 14- on air conditioning unit |
| 16 - | Plug for evaporator vent temperature sender -G263- |
| 17 - | Middle vent temperature sender -G191- |
| q | installed in the intermediate piece for dash panel vents |
| q | to disassemble, remove damping trim panel below the left dash panel and footwell vent on the driver's side, turn sender 90° to the left, take out, lower and release plug |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 18 - | Evaporator vent temperature sender -G263- |
| q | to disassemble, remove dash panel, release plug and pull out sideways |
| q | check → Vehicle diagnostic, testing and information system VAS 5051 |
| 19 - | Sealing ring |
| q | replace if damaged |
| 20 - | Supports |
| q | for cooling the storage tray in the glove compartment |
| q | screwed onto housing |
| 21 - | Connecting hose |
| q | to the storage tray in the glove compartment |