| Removing and installing the cylinder head |
| Special tools and workshop equipment required |
| t
| Guide bolt -MP1-208 (3070)- |
| t
| Rig pin for diesel injection pump -3359- (2x) |
| t
| Crankshaft arrester -T10050- |
| t
| Set of tools 17 mm -T10395- |
| t
| Tensioning strap -T10038- (2x) |
| t
| Open ring spanner 17 mm |
| t
| Catch pan, e.g. -VAS 6208- |
| t
| Old oil collecting and suction equipment, e.g. -V.A.G 1782- |
| t
| Sealant remover gasket stripper (bearing code GST, bearing article no. R 34402), manufacturer Retech s.r.o. |
WARNING | When undertaking all assembly work, particularly in the engine compartment due to its cramped construction, please observe the following: |
| t
| Lay lines of all kinds in such a way that the original line guide is re-established. |
| t
| Ensure that there is adequate free access to all moving or hot components. |
|
|
|
|
