skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing the compression > < Removing and installing the cylinder head|Install

Fabia Mk2

Removing and installing the vacuum pump
Removing and installing the vacuum pump
  WARNING
The vacuum pump must on no account be disassembled, otherwise the proper operation of the pump vacuum part is no longer assured. This will result in a failure of the brake booster.
Removing
–  Remove air filter housing with air mass meter -G70- and intake hose → Chapter.
   
–  Detach the vacuum line -1- from the vacuum pump -2-.
–  Unscrew the fixing screws for the left charge air pipe and afterwards press the left charge air pipe slightly downwards in order to reach the rear bolted connection of the vacuum pump.
  N15-10448
–  Unscrew securing bolts -arrows-.
–  Remove vacuum pump -2- from cylinder head.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  Ensure that the coupling of the vacuum pump is correctly seated in the camshaft.
t  Replace the gasket of the vacuum pump.
–  Install vacuum pumps and tighten fixing screws to 9 Nm.
–  Connect the vacuum line of the brake servo unit to the nozzle -1- of the vacuum pump.
  N15-10448

Testing the compression > < Removing and installing the cylinder head|Install