Fabia Mk2
| Crankshaft - Summary of components |
| 1 - | Bearing shells 1, 2 and 4 |
| q | for bearing cap without lubricating groove |
| q | for cylinder block with lubricating groove |
| q | do not mix up used bearing shells (mark) |
| 2 - | 65 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 3 - | Bearing caps |
| q | Bearing cap 1: on belt pulley side |
| 4 - | Crankshaft |
| q | with chain sprocket for balancing shaft and oil pump drive |
| q | Axial play when new: 0.07…0.17 mm |
| Wear limit: 0,37 mm |
| q | Crankshaft bearing pins: Ø 54.00 mm |
| q | Conrod bearing pin: Ø 47,80 mm |
| 5 - | Bearing shell 3 |
| q | for bearing cap without lubricating groove |
| q | for cylinder block with lubricating groove |
| 6 - | Thrust washers |
| q | Fitting position for bearing 3 → Fig. |
|
|
