Fabia Mk2
Cylinder block - Summary of components |
1 - | Cylinder block |
q | Removing and installing sealing flanges and flywheel → Chapter |
q | Removing and installing crankshaft, piston and conrod → Chapter |
2 - | Knock sensor -G61- |
3 - | 20 Nm |
q | the tightening torque influences the knock sensor function |
4 - | Engine speed sender -G28- |
q | removing and installing → Chapter |
5 - | 5 Nm |
6 - | Gasket |
q | replace |
7 - | Oil filter holder |
q | disassembling and assembling → Chapter |
8 - | 14 Nm + torque a further 180° (1/2 turn) |
q | Screws for balancing shaft module |
q | removing and installing → Chapter |
9 - | 14 Nm + torque a further 90° (1/4 turn) |
q | replace |
q | tighten crosswise |
10 - | 13 Nm |
11 - | 4/2 way valve with coolant regulator |
q | removing and installing → Chapter |
12 - | O-ring |
q | replace |
13 - | Balancing shaft module |
q | removing and installing → Chapter |
14 - | Oil pan |
q | removing and installing → Chapter |
15 - | 15 Nm |
16 - | Screw |
q | for bracket for auxiliary units |
q | replace |
q | Tightening torque as well as sequence for loosening and tightening → Chapter |
17 - | Screw |
q | for bracket for auxiliary units |
q | replace |
q | Tightening torque as well as sequence for loosening and tightening → Chapter |
18 - | Screw |
q | for bracket for auxiliary units |
q | replace |
q | Tightening torque as well as sequence for loosening and tightening → Chapter |
19 - | Bracket for auxiliary units |
q | for engine support, guide pulleys of timing belt, AC generator, AC compressor and tensioning element of the V-ribbed belt |
q | pay attention to the dowel sleeves between the bracket for auxiliary units and the cylinder block |
q | removing and installing → Chapter |
20 - | 25 Nm |
21 - | Lifting eye |
22 - | Screw |
q | replace |
q | Tightening torque as well as sequence for loosening and tightening → Chapter |
23 - | Screw |
q | replace |
q | Tightening torque as well as sequence for loosening and tightening → Chapter |
24 - | Engine support bracket |
q | removing and installing → Chapter |
25 - | Bracket for pre-exhaust pipe |
26 - | 23 Nm |
27 - | 40 Nm |
28 - | Heat shield |
q | for right drive shaft |