Fabia Mk2
Exhaust turbocharger - Summary of components |
Note
t | Observe rules for cleanliness → Chapter. |
t | Observe general instructions for charge-air system → Chapter. |
t | Oil feed line and oil return-flow line for exhaust gas turbocharger - Summary of components → Chapter. |
1 - | Inlet connection |
2 - | 9 Nm |
q | captive at the inlet connection |
3 - | O-ring |
q | replace |
4 - | 15 Nm |
5 - | Support |
q | for electrical cable |
6 - | Heat shield |
7 - | Gasket |
q | replace |
8 - | Exhaust gas turbocharger |
q | can only be replaced complete with exhaust manifold and vacuum setting element |
q | removing and installing → Chapter |
9 - | 25 Nm |
q | replace |
10 - | Exhaust gas temperature sender 1 -G235-, 45 Nm |
q | the thread of a new sender must be coated with assembly paste |
q | coat thread with hot bolt paste -G 052 112 A3- before installing a used sender |
q | for removing and installing, use the wrench -T10395/7- |
q | installing → Chapter |
11 - | Connection fittings |
q | for oil feed line |
q | must not be released, when removing the union nut of the oil feed line counterhold at the hexagon of the connection fitting with adapted fixed spanner 14 mm |
12 - | 15 Nm |
q | replace |
13 - | Heat shield |
14 - | Retaining loop |
q | can only be installed in one position |
15 - | O-ring |
q | replace |
16 - | 9 Nm |
17 - | Pulsation dampener |