Fabia Mk2
1 - | Bearing shells 1, 2 and 4 |
q | for bearing cap without lubricating groove |
q | for cylinder block with lubricating groove |
q | do not mix up used bearing shells (mark) |
2 - | 65 Nm + torque a further 90° (1/4 turn) |
q | replace |
3 - | Bearing caps |
q | Bearing cap 1: on belt pulley side |
q | retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another |
4 - | Bearing shell 3 |
q | for bearing cap without lubricating groove |
q | for cylinder block with lubricating groove |
5 - | Rotor |
q | only for vehicles with engine identification characters BNM, BNV |
q | for engine speed sender -G28- |
q | replace if damaged |
q | removing and installing → Fig. |
6 - | 10 Nm + torque a further 90° (1/4 turn) |
q | only for vehicles with engine identification characters BNM, BNV |
q | replace |
7 - | Fit pin |
q | only for vehicles with engine identification characters BNM, BNV |
q | Checking projection from crankshaft → Fig. |
8 - | Crankshaft |
q | Ø Crankshaft bearing pin: 54.00 mm |
q | Ø Conrod bearing pin: 47.80 mm |
q | Axial play when new: 0.07...0.17 mm |
Wear limit: 0.37 mm |
9 - | Thrust washer |
q | for cylinder block, bearing 3 |
|
Note
|