Removing and installing, testing glow plugs |
For engine with engine code BNM, BNV |
Special tools and workshop equipment required |
t
| Handheld multimeter, e.g. -V.A.G 1526 B- |
–
| Switch off ignition and withdraw ignition key. |
–
| Unplug connector of the glow plugs. |
Installation is performed in the reverse order, pay attention to the following points: |
–
| Install glow plugs and tighten to 15 Nm. |
–
| Unplug connector of the glow plugs. |
–
| Connect handheld multimeter -V.A.G 1526 B- for resistance measurement between contact and glow plug housing. |
l
| Nominal resistance value: less than 1Ω |
If the nominal resistance value is exceeded (greater than 1 Ω), then the glow plug is defective. |
–
| Replace defective glow plug. |
–
| Check glow plugs one after the other in all cylinders. |
–
| Re-insert pulled out plugs of glow plugs. |
|
|
|