skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing the compression > < Removing and installing Hall senderG40

Fabia Mk2

Removing and installing the vacuum pump
Removing and installing the vacuum pump
  WARNING
The vacuum pump must on no account be disassembled, otherwise the proper operation of the pump vacuum part is no longer assured. This will result in a failure of the brake booster.
Removing
–  Remove air filter housing:
t  Fabia II, Roomster, Rapid → Chapter.
t  Octavia II, Superb II, Yeti → Chapter.
   
–  Detach the vacuum line -1- from the vacuum pump -2-.
–  Unscrew the fixing screws of the left charge air pipe and afterwards press the left charge air pipe slightly downwards in order to reach the rear bolted connection of the vacuum pump.
  N15-10448
–  Unscrew fixing screws -arrows-.
–  Remove vacuum pump -2- from cylinder head.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  Pay attention to the correct position of the coupling for the vacuum pump in the camshaft.
t  Always replace the vacuum pump seals.
–  Install vacuum pumps and tighten fixing screws to 10 Nm.
–  Connect the vacuum line -1- of the brake servo unit to the vacuum pump.
  N15-10448

Testing the compression > < Removing and installing Hall senderG40