Fabia Mk2
| Removing and installing parts of the lubrication system - Summary of components |
| 1 - | 15 Nm |
| 2 - | Sealing flange on the belt pulley side |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |
| q | Replace crankshaft seal on belt pulley side → Chapter |
| 3 - | Toothed belt for oil pump |
| q | check for wear and damage, replace if necessary. |
| 4 - | 10 Nm |
| 5 - | Dipstick |
| q | oil level must not exceed max. marking |
| 6 - | Guide tube |
| 7 - | Clip |
| 8 - | Dowel sleeves |
| 9 - | O-ring |
| q | replace |
| 10 - | 10 Nm |
| 11 - | Oil pump |
| q | before installing, check whether both dowel sleeves are present |
| q | if there is any scoring on the contact surfaces of the gears, replace |
| q | Tighening torque of oil pump cover at oil pump housing: 10 Nm |
| 12 - | Intake manifold |
| q | Clean strainer if dirty |
| 13 - | Baffle |
| 14 - | 15 Nm |
| 15 - | 13 Nm |
| 16 - | Oil pan |
| q | removing and installing: |
| t | Fabia II, Roomster, Rapid → Chapter |
| t | Octavia II, Superb II, Yeti → Chapter |
| q | install with silicone sealant -D 176 404 A2- |
| 17 - | 16 Nm |
| 18 - | Drain plug, 30 Nm |
| q | with integrated gasket ring |
| q | replace |
| 19 - | 10 Nm |
| q | replace |
| 20 - | Oil level and oil temperature sender -G266- |
| q | check → Vehicle diagnostic tester |
| 21 - | O-ring |
| q | replace |
| 22 - | Wiring loom to oil level and oil temperature sender |
| 23 - | Pressure relief valve, 27 Nm |
| q | opens at 0.25..0.32 MPa (2.5..3.2 bar) overpressure |
| q | replace without sealant |
| q | removing and installing → Fig. |
| 24 - | Oil injection nozzle |
| q | for piston cooling |
| q | removing and installing → Fig. |
