–
| Apply silicone sealant bead -arrow- to the clean sealing surface of the sealing flange, as shown. |
l
| Thickness of sealant bead -arrow-: 2...3 mm. |
Note t
| The sealant bead must not be thicker than 3 mm otherwise excess sealant may get into the oil pan and clogg the strainer in the oil suction pipe. |
t
| The sealing flange must be installed within 5 minutes after applying the silicone sealant. |
t
| When installing the sealing flange with the gasket ring fitted place a guide sleeve -T10053/1- on the crankshaft journal. |
–
| Carefully push the sealing flange onto the dowel sleeves at the cylinder block and tighten new fixing bolts by hand. |
–
| Tighten the screws of the sealing flange alternately and crosswise to 15 Nm. |
–
| Installing the oil pan: |
–
| Install the new gasket ring for the crankshaft on the belt pulley side → Chapter. |
–
| Installing the timing belt: |
–
| Top up with engine oil and check the oil level: |
|
|
|