Fabia Mk2
|
The exhaust turbocharger and the exhaust manifold are one component part. |
1 - | Exhaust gas turbocharger |
q | only complete with exhaust manifold |
q | removing and installing → Chapter |
q | Remove and install the connection pipe for the suction hose → Chapter |
2 - | Vacuum setting element |
q | with position sender for charge pressure regulator -G581- |
3 - | Connector |
q | to position sender for charge pressure regulator -G581- |
4 - | Heat shield |
q | replace if damaged |
5 - | Gasket |
q | replace |
6 - | 20 Nm |
7 - | Connecting pipe |
q | to radiator for exhaust gas recirculation |
8 - | Exhaust gas temperature sender 1 -G235- |
q | Tightening torque: 45 Nm |
q | coat thread with hot bolt paste -G 052 112 A3- before installing |
q | removing and installing → Chapter |
9 - | 10 Nm |
10 - | Support |
q | for oil feed line |
11 - | Heat shield |
12 - | 10 Nm |
13 - | Support for exhaust gas turbocharger |
q | removing and installing → Chapter |
14 - | Sealing ring |
q | replace |
15 - | Hollow screw, 60 Nm |
q | replace |
16 - | Oil return-flow line |
17 - | 20 Nm |
18 - | Hollow screw, 30 Nm |
q | replace |
19 - | Sealing ring |
q | replace |
20 - | Oil feed line |
q | removing and installing → Chapter |
q | check continuity |
q | before installing, fill the exhaust turbocharger on the connection fitting for the oil feed line with engine oil |
21 - | Pulsation dampener |
22 - | 10 Nm |