skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Checking the coolant system for leaktightness > < Draining and filling up coolant

Fabia Mk2

Removing and installing radiator
Removing and installing radiator
Special tools and workshop equipment required
t  Catch pan, e.g. -VAS 6208-
t  Pliers for spring strap clamps
Removing
–  Remove front bumper → Body Work; Rep. gr.63.
  Note
Collect drained coolant in a clean container for proper disposal or reuse.
–  Drain coolant → Chapter.
–  Pull off coolant hose at the top and bottom of the radiator.
   
–  Disconnect plug -1- from thermoswitch for radiator fan -F18- and plug -2- from radiator fan -V7-.
Vehicles with air conditioning
  WARNING
Do not open the refrigerant circuit of the air conditioning system.
–  Unscrew screws of brackets for the refrigerant lines at the fan shroud and at the radiator.
Continued for all vehicles
–  Remove headlights → Electrical System; Rep. gr.94.
  S19-0078
–  Release screws -arrows- and remove fan shroud with fan.
Vehicles with air conditioning
  Note
t  To avoid causing damage to the condenser and to the refrigerant lines and hoses make sure the lines and hoses are not over-extended, kinked or bent.
t  Do not simply suspend AC condenser on the refrigerant lines. Pay attention to a correct suspension or support.
  S34-1076
–  Unscrew fixing screws for AC compressor -arrows- and suspend condenser laterally.
–  Unscrew fixing screws for radiator bearing on right and left.
–  Incline the radiator slightly backwards and pull out upwards.
Vehicles without air conditioning
–  Unscrew fixing screws for radiator bearing on front right and left.
–  Incline the radiator slightly backwards and pull out upwards.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–  Top up coolant → Chapter.
  S19-0081

Checking the coolant system for leaktightness > < Draining and filling up coolant