skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing air filter housing > < Air filter housing - Summary of components

Fabia Mk2

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
The engine speed sender -G28- is integrated in the sealing flange on the flywheel side.
Special tools and workshop equipment required
t  Socket insert 4 mm -T10370-
t  Assembly device -T10118-
Removing
–  Remove the noise insulation.
   
–  Disconnect the plug -arrow- for the engine speed sender -G28- using the assembly device -T10118-.
  Note
To disconnect the plug without using the assembly device -T10118-, carefully lever off the plug with a suitable screwdriver and at the same time lift up the release button with a thin wire hook.
  N15-0605
–  Release the fixing screw -arrow- and pull out the engine speed sender -G28-.
Install
The installation of the engine speed sender -G28- occurs in reverse order, while paying attention to the following:
Tightening torque of the fixing screw: 5 Nm
  N13-10048

Removing and installing air filter housing > < Air filter housing - Summary of components