Fabia Mk2
| Timing belt drive - Summary of components |
| 1 - | Top toothed belt guard |
| 2 - | 20 Nm + torque a further 1/4 turn (90°) |
| q | replace |
| q | to release and tighten use camshaft lock -T10016- |
| 3 - | Camshaft sprocket |
| q | take note of the position when installing the timing belt → Chapter |
| 4 - | Coupling drive tensioning pulley |
| q | check → Chapter |
| q | Tensioning toothed belt → Chapter |
| 5 - | Coupling drive - toothed belt |
| q | before removing mark running direction |
| q | check for wear |
| q | do not kink |
| q | removing and installing, tensioning → Chapter |
| 6 - | 10 Nm |
| 7 - | Coolant pump |
| q | if damage and leak present - replace completely |
| q | removing and installing → Chapter |
| 8 - | Rear toothed belt guard |
| 9 - | 20 Nm |
| 10 - | 50 Nm |
| 11 - | Guide pulley |
| 12 - | Tensioning pulley |
| q | check → Chapter |
| q | Tensioning toothed belt → Chapter |
| 13 - | Crankshaft - toothed belt sprocket |
| q | take note of the position when installing the timing belt → Chapter |
| 14 - | Main drive toothed belt |
| q | before removing mark running direction |
| q | check for wear |
| q | do not kink |
| q | Routing of toothed belt → Fig. |
| q | removing and installing, tensioning → Chapter |
Note| If the toothed belt is replaced within the scope of engine repair (apart from change intervals), it should be entered in the Service Schedule! |
| 15 - | 12 Nm |
| q | replace |
| 16 - | Belt pulley |
| q | pay attention to the locating element when installing |
| 17 - | 150 Nm + torque a further 1/2 turn (180°) |
| q | replace |
| q | The contact surfaces of the fixing screw and the belt pulley must be free of grease and oil |
| q | Oil the thread of the screw |
| q | Counterhold belt pulley with counterholder -T30004 (3415)- with bolt -T30004/1 (3415/1)- |
| q | tightening may occur in successive stages |
| q | the torquing angle can be measured with a commercially available angle measuring plate, e.g. -Hazet 6690- |
| 18 - | V-ribbed belt |
| q | mark the direction of rotation with chalk or a felt-tip pen before removing |
| q | check for wear |
| q | removing and installing → Chapter |
| q | Routing of the ribbed V-belt → Chapter |
| 19 - | Bottom toothed belt guard |
| 20 - | Console |
| 21 - | 50 Nm |
| q | replace |
|
|
