| –
| Expose wiring loom and disconnect the plug connection from the key module. |
| –
| Tilt out the key module -1--arrow A- until the locking bolts are slackened, move slightly into the centre of the steering wheel -arrow B- and remove. |
| Installation is performed in the reverse order, pay attention to the following points: |
Note | Before the airbag is installed, it must be checked if all the wiring is properly pressed back into the guiding grooves in the steering wheel foam. Wiring which protrudes can be damaged by the backside parts of the airbag. |
| –
| If the key module with the integrated control unit was replaced, then the coding must be carried out with the → Vehicle diagnostic tester. |
|
|
|
