skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the lift cylinder for spray nozzles of headlights - up to MY 2010 > < Removing and installing headlight cleaning system pumpV11

Fabia Mk2

Removing and installing the spray nozzle holder - up to MY 2010
Removing and installing the spray nozzle holder - up to MY 2010
On vehicles as of MY 2011, the holder cannot be removed.
If only the spray nozzle holder is removed, then the bumper must be removed.
Removing
   
–  Pull the spray nozzles with cover -1- slightly out of the bumper by uniformly gripping on both sides of the cover, then grip the spray nozzles and pull out up to the stop.
–  Unclip the cover -1- from the bearing -arrows- of the spray nozzle holder.
  N92-10099
–  Slightly raise securing clip -arrow- and pull out spray nozzle holder.
Install
  Note
Catches on the spray nozzle are intended to push the cover for the spray nozzle holder into the bumper as far as possible. If the spray nozzle holder is pushed too far into the lift cylinder for spray nozzles, the cover or the bumper can be deformed. If the spray nozzle holder is pushed in a little, there is a gap between the cover and the bumper.
–  Clip cover onto the holder.
–  Push the holder with cover into the lift cylinder for spray nozzles until the cover is tightly fit on the bumper.
–  After installing the holder bleed the headlamp cleaning system → Chapter.
–  Perform a functional check or adjust nozzles → BookletRoomster
  N92-10014

Removing and installing the lift cylinder for spray nozzles of headlights - up to MY 2010 > < Removing and installing headlight cleaning system pumpV11