skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Headlamp cleaning system > < Removing and installing wiper motor
Replacing and adjusting the spray nozzle.
Replacing and adjusting the spray nozzle.
Removing
–  Open cap of rear window wiper.
   
–  Use suitable pliers to carefully pull out spray nozzle in direction of arrow.
Install
–  Run wiper until it is in park position → Chapter.
–  Push spray nozzle fully into the wiper arm shaft so that the opening of the spray nozzle is facing vertically up.
  S92-0036
–  The spray should strike the rear window as shown in the illustration when the vehicle is stationary. The value -a- is 200 mm. The cross -1- shows the fluid point of impact.
  S92-0081

Headlamp cleaning system > < Removing and installing wiper motor