skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Rear spoiler (for vehicles Octavia Combi RS) > < Summary of the components - for the complete rear spoiler

Octavia Mk1

Removing and installing complete rear spoiler
Removing and installing complete rear spoiler
Special tools and workshop equipment required
t  Cutting wire with holders e.g. -V.A.G 1351-
t  Adhesive cement -Terostat 9120- - white part no. HHA 381 013
t  Cleaning solution -HHA 381 011-
Removing the spoiler
–  Cut off the spoiler from the tailgate (cut through the adhesive cement).
–  Remove the spoiler.
Installing the spoiler
   
–  Remove dowel sleeve -1- and clips -2- from the spoiler.
–  Clean the seating area of the spoiler as well as the tailgate with universal cleaning agent -D 009 401 04- while observing the instructions for the adhesive cement issued by the manufacturer.
–  Apply the adhesive cement all around the spoiler while observing the instructions issued by the manufacturer.
–  Push the spoiler onto the tailgate (4.7 ±1 mm from the tailgate edge to the spoiler edge).
The dimension 4.7 ±1 mm must be the same on the left and the right side of the tailgate.
–  Secure position of the rear apron with adhesive tape.
–  Remove any dirt present using a cleaner.
  Note
t  The glue sealing mass must dry for 24 hours. Do not drive the vehicle in this time.
t  Do not drive into the carwash within 24 hours of gluing on the spoiler.
  S66-0122

Rear spoiler (for vehicles Octavia Combi RS) > < Summary of the components - for the complete rear spoiler