skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Waiting time > < Prepare flange for fitting

Octavia Mk1

Glueing
Glueing
   
–  After completing the preparations cut the nozzle for applying the glue into shape as shown in the figure.
–  Dimension -a- 12 mm.
–  Bead width 8 mm.
–  Application direction -arrow-.
  Note
t  The bead section is dependent on the section of the nozzle and the application speed.
t  When using a 1K window pane adhesive -DH 009 100- or -DH 009 100 03-, preheat the glue cartridges for 20 minutes in the warming box -V.A.G 1939A-.
t  When using a 2K window pane adhesive -DH 004 300 05- mix the components with mixer -D 009 700-.
  WARNING
Comply with the manufacturer's handling instructions.
  Note
Use disposable gloves when working with glues and adhesive materials.
  S64-0022
–  Apply the adhesive cement to the sealing section -1- perpendicularly to the window surface and all around it.
  Note
t  Apply adhesive cement at a temperature of 10 to 30°C.
t  Open all vehicle windows before fitting the window into the frame.
–  Insert the window in the frame using double nipple gripper (V.A.G 1344), centre and press onto the spacer catches.
  WARNING
Fit the window immediately as otherwise the adhesive properties of the glue decrease considerably.
–  Insert window in frame with positioning wedges if necessary eccentrics (applies for windscreen).
–  Fix the window during hardening process with adhesive tape.
–  Any adhesive cement which was applied too thickly and is pressed out up to the heating filaments of the rear window heating must be removed.
  V64-0209

Waiting time > < Prepare flange for fitting