skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fault table for vehicles 10.97 ? (2nd generation central locking) > < Interrogating fault memory

Octavia Mk1

Fault table for vehicles ► 09.97 (1st generation central locking)
Fault table for vehicles ► 09.97 (1st generation central locking)
  Note
t  Below is a list of all possible faults detected by the central locking control unit -J110- and displayed on -V.A.G 1552-, arranged according to their 5-digit fault code.
t  Before replacing components found to be defective first check the wiring and plug connections to these components as well as the earth cables according to the current flow diagram.
t  Check tight fit of all the plug connections on the relay plate.
t  After repair always interrogate the fault memory using the vehicle system tester -V.A.G 1552- and erase the memory.
t  The fault table may also display the fault type.
   
Readout on -V.A.G 1552-Possible cause of faultRectifying fault
00000
no fault detected		If after repair „No fault detected“ is displayed, the self-diagnosis is completed.
65535  
Control unit defective
t  Wiring or plug connections defective
t  Control unit CL defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace control unit CL
00668  
El. syst. voltage tml. 30  
Signal too low
t  Battery discharged
t  Wiring or plug connections defective
–  Charging battery
–  Check wiring and plug connections according to the current flow diagram
00849  
S contact
Undefined switch status
t  Terminal 15 O.K., S contact defective
t  Wiring or plug connections defective
–  Read measured value block, display group number 006 → Anchor
–  Check wiring and plug connections according to the current flow diagram
00928  
CL lock unit driver's side -F220-
Implausible signal
t  Locking unit -F220- defective
t  Wiring or plug connections defective
t  No supply voltage for CL on driver's door
t  Resistance in the mechanism of the locking unit and control elements

–  Replace locking unit
–  Check cables, plug connections and door locks in accordance with the current flow diagram
–  Inspect supply voltage
–  Check mechanism and ensure smooth operation
–  Read measured value block, display group number 004 → Anchor
00929  
CL lock unit front passenger side -F221-
Implausible signal
t  Locking unit -F221- defective
t  Wiring or plug connections defective
t  No supply voltage for CL on passenger's door
t  Resistance in the mechanism of the locking unit and control elements

–  Replace locking unit
–  Check cables, plug connections and door locks in accordance with the current flow diagram
–  Inspect supply voltage
–  Check mechanism and ensure smooth operation
–  Read measured value block, display group number 004 → Anchor
00930  
CL lock unit
rear left - F 222

Implausible signal
t  Locking unit -F 222- defective
t  Wiring or plug connections defective
t  No supply voltage for CL on rear left door
t  Resistance in the mechanism of the locking unit and control elements

–  Replace locking unit
–  Check wiring and plug connections according to the current flow diagram
–  Inspect supply voltage
–  Check mechanism and ensure smooth operation
–  Read measured value block, display group number 003 → Anchor
00931  
CL lock unit
rear right -F223-
t  Locking unit -F223- defective
t  Wiring or plug connections defective
t  No supply voltage for CL on rear right door
t  Resistance in the mechanism of the locking unit and control elements

–  Replace locking unit
–  Check wiring and plug connections according to the current flow diagram
–  Inspect supply voltage
–  Check mechanism and ensure smooth operation
–  Read measured value block, display group number 003 → Anchor
00945  
Crash sensor for front airbag -G190-  
Short circuit to earth
t  Wiring or plug connections defective
–  Check wiring and plug connections according to the current flow diagram
–  The outlet can also be checked with the final control diagnosis for airbag → Chapter
00946  
Interior lamp  
Short circuit to positive
t  Wiring or plug connections defective
t  Interior light or one of the reading lights defective
–  Check cables, plug connections and door locks in accordance with the current flow diagram
–  Replace light
–  Read measured value block, display group number 004 → Anchor
00947  
Switch for tailgate remote release  
Short circuit to earth
t  Wiring or plug connections defective
t  Switch defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace switch
00949  
Motor for CL tailgate LOCK - V 53
(locked)

Undefined switch status
t  Motor for CL tailgate defective
t  Wiring or plug connections defective
t  Lock control mechanism defective
–  Replace motor for CL tailgate
–  Check wiring and plug connections according to the current flow diagram
–  Check lock control mechanism and ensure smooth operation
00950  
Motor for CL tailgate UNLOCK - V 53 (unlocked)

Undefined switch status
t  Motor for CL tailgate defective
t  Wiring or plug connections defective
t  Lock control mechanism defective
–  Replace motor for CL tailgate
–  Check wiring and plug connections according to the current flow diagram
–  Check lock control mechanism and ensure smooth operation
00951  
Tailgate remote release relay -J398-  
Short circuit to positive
t  Wiring or plug connections defective
–  Check wiring and plug connections according to the current flow diagram
00953  
Time limit of interior light  
Undefined switch status
t  Wiring or plug connections defective
t  Defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace interior light
00954  
Terminal 50 relay  
Short circuit to positive
t  Wiring or plug connections defective
–  Check wiring and plug connections according to the current flow diagram
00955  
Key 1 outside of reception range
Adaption limit exceeded
t  Key not adapted
t  Key was operated over 200 times outside the reception range
–  Read measured value block, display group number 008 → Anchor
–  Perform adaptation → Chapter
00956  
Key 2 outside of reception range
Adaption limit exceeded
t  Key not adapted
t  Key was operated over 200 times outside the reception range
–  Read measured value block, display group number 008 → Anchor
–  Perform adaptation → Chapter
00957  
Key 3 outside of reception range
Adaption limit exceeded
t  Key not adapted
t  Key was operated over 200 times outside the reception range
–  Read measured value block, display group number 008 → Anchor
–  Perform adaptation → Chapter
00958  
Key 4 outside of reception range
Adaption limit exceeded
t  Key not adapted
t  Key was operated over 200 times outside the reception range
–  Read measured value block, display group number 008 → Anchor
–  Perform adaptation → Chapter
00960  
Key switch CL driver's side  
Implausible signal

Short circuit to earth
t  Wiring or plug connections defective
t  Switch defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace switch
–  Read measured value block, display group number 001 → Anchor
00961  
Key switch CL front passenger side  
Short circuit to earth
t  Wiring or plug connections defective
t  Switch defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace switch
–  Read measured value block, display group number 002 → Anchor
01131  
Turn signal control  
Open circuit/short circuit to positive


short circuit to earth
t  Bulbs defective
t  Wiring or plug connections defective
–  Replace light bulb
–  Check wiring and plug connections according to the current flow diagram
01134  
Alarm horn -H12-  
Undefined switch status
t  Alarm horn defective
t  Fuse defective
t  Wiring or plug connections defective
–  Replace alarm horn
–  Replace fuse
–  Check wiring and plug connections according to the current flow diagram
01135  
Interior monitoring sensor 1)  
Open circuit in wiring/defective
t  Sensor -G273- defective
t  Sensor -G273- not installed
t  Wiring or plug connections defective
–  Replace sensor
–  Check connection
–  Check wiring and plug connections according to the current flow diagram
01179  
Key programming wrong 
–  Program key again → Chapter, adaptation
01356  
Signal: close all windows and sliding roof 2)  
Short circuit to positive
t  Wiring or plug connections defective
t  Sliding roof motor -V1- defective
–  Check wiring and plug connections according to the current flow diagram
–  Replace sliding roof motor -V1-
01362  
Lock key button tailgate -F124-  
Short circuit to earth
t  Resistance in lock control mechanism or lock cylinder
t  Wiring or plug connections defective
–  Check lock control mechanism and ensure smooth operation
–  Replace lock cylinder
–  Check cables, plug connections and door locks in accordance with the current flow diagram
–  Read measured value block, display group number 004 → Anchor
–  Read measured value block, display group number 006 → Anchor
01389  
Unlock key button tailgate -F124-  
Short circuit to earth
t  Resistance in lock control mechanism or lock cylinder
t  Wiring or plug connections defective
–  Check lock control mechanism and ensure smooth operation
–  Replace lock cylinder
–  Check cables, plug connections and door locks in accordance with the current flow diagram
–  Read measured value block, display group number 004 → Anchor
–  Read measured value block, display group number 006 → Anchor

1) not installed on vehicles OCTAVIA.
2) only the close sliding roof signal is used for OCTAVIA
   

Fault table for vehicles 10.97 ? (2nd generation central locking) > < Interrogating fault memory