skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Reading measured value block > < Ending output

Octavia Mk1

Coding control unit
Coding control unit
–  Connecting vehicle system tester -V.A.G 1552- and selecting the address word for the convenience system → Chapter.
   
Readout on display:
–  Enter function 07.
  
Vehicle system test                Help
Enter address word XX
Readout on display:
–  Confirm the entry with key Q.
  
Vehicle system test                Q 
07 - Code control unit
Readout on display:
–  Enter code number following table:
Table of codes for convenience system of 1st, 2nd and 2nd/5th generation
  
Code control unit                 Q 
Enter code number XXXXX     (0–32767)
 Code number
Central locking systemIndividual door opening04096
 Overall opening04097
 Individual door opening1)01024
 Overall opening1)01025

1) Valid for Switzerland
Table of codes for 3rd generation convenience system
   
 Code number
Basic entry code (all vehicle equipments) Octavia00002
Central locking without power-window lifter00016
Central locking and electric window lifters (2 windows)00064
Central locking and electric window lifters (4 windows)00256
Individual door opening00000
Overall opening00001

In order to determine the code for the convenience system, it is necessary to add further codes to the basic entry code depending upon vehicle equipment.
Example
Should be selected: Central locking, electric window lifters (2 windows) and overall opening.
00002 + 00064 + 00001 = 00067
For all vehicles:
–  Confirm the entry with key Q.
   
The control unit identification number → Chapter, the control unit code number and the workshop code (current versions of the control units see Catalogue of Original Parts) are displayed.
If the indicated display content appears, the coding was successful.
  
1J0959799AH  Central CU comf.       0001 ->
Coding  04097                 WSC XXXXX
If the control unit rejects an entered code number the following message will be displayed:
In this case the control unit was not coded with the data required for the vehicle. Check whether the right control unit was fitted on the vehicle (compare part number and character index) and whether possibly a wrong code was entered.
–  Repeat coding.
If the control unit cannot be coded (correct part number, correct code number) the control unit must replaced with a new original part.
–  Ending output → Chapter.
  
FAULT                                 ->
    Coding XXXXX not accepted

Reading measured value block > < Ending output