Octavia Mk1
Note
|
1 - | Brake servo unit without mechanical brake assistance |
t | Right-hand drive vehicles with ABS/EDL/TCS/ESP Mark 60 |
t | Left-hand drive vehicles with ABS/EDL/TCS/ESP Mark 60 up to and including model year 2001 |
- Brake servo unit with mechanical brake assistance |
t | Left-hand drive vehicles with ABS/EDL/TCS/ESP Mark 60 as of model year 2002 |
t | The brake assistance can only be recognized by the spare part number of the brake servo unit |
t | The brake assistance cannot be repaired, replace the brake servo unit completely when handling a fault LHD vehicles → Chapter, RHD vehicles → Chapter |
- Continued for all brake servo units |
t | check → Chapter |
t | removing and installing LHD vehicles → Chapter, RHD vehicles → Chapter |
t | if there are faults replace completely |
t | separate from brake pedal → Chapter |
t | on petrol engines the required negative pressure is drawn from the induction pipe |
t | vehicles using a diesel engine are fitted with a vacuum pump for generating a low pressure |
t | the electric brake vacuum pump is additionally installed on vehicles with automatic gearbox and in combination with EU4 -V192- |
t | -V192- check operation → Chapter |
t | Remove and install the brake vacuum pump -V192- → Chapter |
t | Non-return valve (in the vacuum hose of the vacuum pump) |
Check for proper operation |
– | It must be possible to blow through the valve in the -direction of the arrow-. |
– | Against the direction of the arrow the valve must be closed. |
2 - | Screw cap |
t | with integrated brake fluid level warning contact -F34- |
3 - | Brake fluid reservoir, left-hand drive |
t | locked with lateral catches in the retaining pin |
4 - | Sealing plugs |
t | moistened with brake fluid, press in expansion reservoir |
5 - | Retaining pin |
t | fit through the master brake cylinder |
6 - | Hauptbremszylinder |
t | cannot be repaired, replace completely in the event of faults |
7 - | Retaining bracket |
t | serves to fix the wiring loom |
8 - | Self-locking nut 20 Nm |
t | always replace |
9 - | Heat shield |
t | only for vehicles with 74 kW, 92 kW, 110 kW and 132 kW engine |
10 - | Brake pressure sender -1--G201- |
t | removing and installing → Chapter |
11 - | Sealing ring |
t | always replace |
12 - | Sealing plugs |
t | Connection for vacuum hose |
t | insert in brake servo unit. |
13 - | Gasket |
t | for brake servo unit |
t | between brake servo unit and bulkhead |
t | always replace |
14 - | Self-locking nut 20 Nm |