Octavia Mk1
|
| 1 - | Brake servo unit with master brake cylinder and brake fluid reservoir |
| t | Summary of components → Chapter |
| 2 - | Hydraulic control unit 1) |
| t | Fitting position: in left of engine compartment |
| t | removing and installing → Chapter |
| t | repairing → Chapter |
| 3 - | Diagnostic connection |
| t | Fitting location: in the storage compartment on the driver's side |
| 4 - | ABS warning light -K47- |
| t | Fitting location: in the dash panel insert, function: |
| t | The ABS warning light comes on: |
| – | for about 2 seconds after the ignition is switched on or the engine is started |
| – | if a fault is detected (e.g. open circuit to wheel speed sensor) → Chapter |
| 5 - | Hand brake/brake fluid level warning light -K14/33- |
| t | Fitting location: in the dash panel insert, function: |
| t | The hand brake/brake fluid level warning light comes on: |
| – | if hand-brake is applied |
| – | if low brake fluid level |
| – | for about 2 seconds after ignition is switched on |
| – | if the electronic brake pressure distribution fails, i.e. when the ABS warning light comes on → Chapter |
| 6 - | Parts of ABS system on rear axle |
| (only disc brake shown in illustration) |
| t | Rear right and rear left wheel speed sensors -G44/G46-1) |
| – | removing and installing → Chapter |
| – | Installing wheel speed sensor cables → Chapter |
| t | Pulse rotor for the wheel speed sensor at the rear on the right and left |
| – | check → Chapter |
| – | removing and installing: The pulse rotor must be changed together with the wheel hub → Chapter and → Chapter |
| 7 - | Brake light switch -F- |
| t | is open in off position |
| – | setting up to MY 1999 → Chapter, as of MY 2000 → Chapter |
| – | removing and installing up to MY 1999 → Chapter, as of MY 2000 → Chapter |
| t | must be tested in the measured value block → Chapter |
| 8 - | Parts of ABS system on front axle |
| t | Front right and front left wheel speed sensors -G45/G47-1) |
| – | removing and installing → Chapter |
| – | Installing wheel speed sensor cables → Chapter |
| t | Pulse rotor for the wheel speed sensor at the front on the right and left |
| – | check → Chapter |
| – | removing and installing: The pulse rotor must be changed together with the wheel hub → Chapter |
