skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Multi-pin plug connection with contact assignment > < Electrical test of the ABS and ABS/EDL ITT Mark 20 IE

Octavia Mk1

Test conditions
Test conditions
l  The fuses must be OK in compliance with the current flow diagram → binder „Current Flow Diagrams, Electrical Fault Finding and Fitting Locations“ To check, remove fuses from the fuse holder on the battery and the fuse holder on the left of the dash panel.
l  Before starting the test switch off the ignition and electrical consumers (headlights, lighting, blowers etc.).
   
l  Remove the multi-pin plug connection from the ABS control unit -J104- and connect the test box -V.A.G 1598/21--1- to the plug of the wiring loom -2-.
The specified values are specific to the -V.A.G 1526 A- and do not necessarily apply for other measuring tools.
  S01-0046

Multi-pin plug connection with contact assignment > < Electrical test of the ABS and ABS/EDL ITT Mark 20 IE