skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing hand-brake cable (disc brake) > < Setting the hand-brake (disc brake)

Octavia Mk1

Removing and installing hand-brake cable (drum brake)
Removing and installing hand-brake cable (drum brake)
Removing
–  Remove rear centre console → Body Work; Rep. gr.68.
–  Release the hand-brake.
   
–  Release the adjusting nut -1- so far until the hand-brake cable can be unhooked from the compensating clamp -2-.
–  Raise vehicle.
–  Remove wheel.
–  Remove the brake drum.
–  Unhook the hand-brake cable from the brake lever on the brake shoe.
  S46-0081
–  Unclip hand-brake cable from the clip on the rear axle body -arrow A- and unhook from the brackets -arrows-.
  N46-0180
–  Pull hand-brake cable -2- in the direction of the arrow out of the guide tube -1-.
Install
Installation is carried out in the reverse order.
  Note
t  When installing the hand brake cables, pay attention to the correct fitting position → Chapter.
t  Before setting the hand-brake, pretension the hand-brake cable with the adjusting nut at the compensation clamp.
t  Setting the hand-brake → Chapter.
  S46-0082

Removing and installing hand-brake cable (disc brake) > < Setting the hand-brake (disc brake)