skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Brakes, hydraulics, regulator, servo > < Separating the brake pedal from the brake servo unit and clipping

Octavia Mk1

Removing and installing brake pedal
Removing and installing brake pedal
Special tools and workshop equipment required
t  Release tool -T10159A-
t  Grease MoS2 (molykote grease)
Removing
   
–  Release screws -2-.
–  Pull the footwell covering -1- out of the holders.
Only for LHD vehicles
  S47-0061
–  Release screws -1-.
–  Take off cover -A-.
  S47-0026
–  On vehicles with manual gearbox, remove the connecting plate between the clutch pedal and the brake pedal -arrows-.
–  Unhook throttle control cable.
–  On vehicles with accelerator pedal position sender, disconnect the plug connection below the dash panel.
Continued for all vehicles
–  Removing brake light switch vehicles up to MY 1999 → Chapter, vehicles as of MY 2000 → Chapter.
–  Separating the brake pedal from the brake servo unit → Chapter.
–  Remove all the fixing nuts of the foot controls.
RHD vehicles
–  Remove the nut for the strut attached to the mounting bracket and divert the strut.
Continued for all vehicles
–  Remove foot controls.
–  Remove screwed connection of mounting bracket - brake pedal.
–  Remove brake pedal.
Install
  Note
Grease all bearing and contact surfaces with grease MoS2.
Installation is carried out in the reverse order.
–  Installing and setting brake light switch vehicles up to MY 1999 → Chapter, vehicles as of MY 2000 → Chapter.
  A47-0031
Tightening torques:
Brake pedal to bracket
t  Use new screws and nuts!
25 Nm
Brake servo unit to mounting bracket
t  Use new nuts!
28 Nm
Connecting plate between clutch pedal and brake pedal20 Nm

   

Brakes, hydraulics, regulator, servo > < Separating the brake pedal from the brake servo unit and clipping