skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Bleed brake system, vehicles with or without ABS or ABS/EDL Mark 20 and Mark 60 > < Inspecting and adjusting the brake-power regulator

Octavia Mk1

Adjusting values for the load-dependent brake-power regulator
   
Adjusting values for the load-dependent brake-power regulator
Model/Version barMPa barMPa
Drum brakes on the Front axle707Front axle10010
Rear axleRear axle41 ... 474,1 ... 4,7Rear axle54 ... 605,4 ... 6,0

Adjusting brake-power regulator
Test pressure on rear axle too high:
–  Release tension spring on brake-power regulator.
Test pressure on rear axle too low:
–  Tighten tension spring on brake-power regulator.
  Note
Adjust without load on the brake pedal, observe the following sequence:
–  Read off values.
–  Release brake pedal.
–  Adjust tension spring on brake-power regulator.
–  Again load brake pedal.
–  Read-off values and if necessary correct adjustment.
–  Remove pressure gauge.
–  Bleeding Brake System → Chapter.
   

Bleed brake system, vehicles with or without ABS or ABS/EDL Mark 20 and Mark 60 > < Inspecting and adjusting the brake-power regulator