Octavia Mk1
Note
|
| 1 - | Self-locking screw, 35 Nm |
| t | replace |
| t | counterhold on the guide bolt when releasing and tightening |
| 2 - | Vent valve, 10 Nm |
| t | thinly coat thread with brake fluid or assembly paste before screwing in -G 052 150 A2- |
| 3 - | Dust cap |
| 4 - | Guide bolt |
| t | grease before fitting protective cap |
| 5 - | Protective cap |
| t | pull onto brake carrier and guide bolt |
| 6 - | Brake carrier with guide bolts and protective caps |
| t | must be assembled with sufficient grease on the guide bolt, supplied as a spare part |
| t | if there is any damage to the protective caps or guide bolts fit a repair set (use the enclosed grease packing to lubricate the guide bolts) |
| 7 - | Protective cap |
| t | pull with outer sealing lip onto the piston |
| t | insert with the inner sealing lip into the groove of the brake caliper housing → Chapter |
| 8 - | Piston with automatic adjusting device |
| t | removing and installing → Chapter |
| t | thinly coat piston with brake fluid or assembly paste before installing -G 052 150 A2- |
| 9 - | Sealing ring |
| t | take out with a plastic wedge → Chapter |
| 10 - | Brake caliper housing with lever for the handbrake cable |
| t | replace brake caliper housing if the lever for the handbrake cable is not sealed |
| t | pre-bleed brake caliper housing after undertaking repairs → Chapter |
