Octavia Mk1
| Summary of components - Assembly carrier with final drive |
| 1 - | 60 Nm |
| 2 - | Cross member |
| 3 - | Rubber-metal bearing for final drive |
| t | removing and installing → Chapter |
| t | Observe fitting position: kidney-shaped openings or arrow must point vertically upwards or downwards |
| 4 - | Rubber-metal bearings for assembly carrier |
| t | are supplied as spare parts in a sealed plastic bag |
| t | do not use any rubber-metal bearings which have been stored openly |
| t | removing and installing → Chapter |
| t | Observe fitting position: ribbed side must point upwards |
| 5 - | 110 Nm + 90° |
| t | replace after each removal |
| 6 - | Assembly carrier |
| t | removing and installing → Chapter |
| 7 - | Support for final drive |
| 8 - | 40 Nm + 45° |
| t | M10 x 40 |
| t | replace after each removal |
| 9 - | 40 Nm + 45° |
| t | M10 x 55 |
| t | replace after each removal |
| 10 - | Rear final drive |
| t | removing and installing → manual gearbox; Rep. gr.39. |
| 11 - | Self-locking nut, 25 Nm |
| t | replace after each removal |
| 12 - | Anti-roll bar |
| 13 - | 20 Nm |
| t | mate both screws and initially tighten to 5 Nm, subsequently tighten |
| 14 - | Clamp |
| 15 - | Coupling rod |
