–
| Release counternut -1 -. |
–
| Adjust track by turning the left and/or right track rod. |
Position open-end wrench on hexagon -arrow-. |
Check that the bellows have not become twisted after turning the track rods! |
Twisted bellows wear fast. Bellows replace if damaged. |
–
| Tighten counternut -1- with 50 Nm and again check track value. |
After tightening counternut -1- the set value may change slightly. |
Make sure this value remains within the tolerance for the nominal value. If this is not the case repeat the track adjustment operation. |
|
|
|