Octavia Mk1
| Installed location of individual parts for engines with the engine codes AXP |
| 1 - | Fuel pressure regulator |
| 2 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42- |
| q | Specified resistance → Fig. |
| 3 - | Intake manifold |
| 4 - | Injector (-N30- ... -N33-) |
| 5 - | Engine control unit |
| (Motronic control unit -J220-) |
| q | below the water box cover |
| 6 - | Knock sensor 1 -G61- |
| q | removing and installing → Chapter |
| 7 - | Throttle valve control unit -J338- |
| 8 - | Earth connection |
| 9 - | Engine speed sender -G28- |
| q | Fitting location: Cylinder-block intake side |
| q | → Anchor, position 14 |
| 10 - | 3-pin connector |
| q | grey for engine speed sender -G28- |
| 11 - | Ignition transformer -N152- |
| q | with identification for ignition leads, do not switch |
| q | removing and installing → Chapter |
| 12 - | 6-pin plug connection |
| q | black |
| q | for lambda probe and lambda probe heater |
| 13 - | Coolant temperature sender -G62 - |
| q | with coolant temperature gauge -G2- |
| q | check → Fig. |
| 14 - | with EGR valve - N18- with EGR potentiometer -G212- |
| 15 - | Hall sender - G40- |
| q | removing and installing → Chapter |
| 16 - | Lambda probe before catalyst -G39-, 50 Nm, lambda probe after catalyst -G130-, 50 Nm |
| q | Fitting location: Lambda probe upstream of catalytic converter in exhaust manifold, lambda probe downstream of catalytic converter behind main catalytic converter |
| 17 - | Activated charcoal filter system solenoid valve 1 -N80- |
| q | Activated charcoal filter → 1.4 ltr./55 kW Engine, Mechanical Components; Rep. Gr.20 |
