(1 to 4 = display fields) |
Engine operating condition (display group 4): |
| In idle operation display field 4 must display “idle”. |
| Display field 4 must display “partial load”. |
–
| Engine speed must increase to more than 3000 rpm. |
–
| Then close the throttle valve promptly. |
| Display field 4 must display “trailing throttle”. |
–
| Briefly apply full throttle. |
| Display field 4 must display “full load”. |
Note t
| To obtain the display full load, it may be necessary to perform a test drive. |
t
| A second mechanic is required for the test drive. |
WARNING Secure the vehicle system tester to the rear seat and operate from that position. |
|
–
| Enter 06 for the function “End output” and confirm the entry with key Q. |
If the specified values are not reached: |
–
| Interrogate fault memory, rectify any faults existing and erase the fault memory → Chapter. |
–
| Check accelerator pedal position sender -G79- → Chapter. |
–
| Inspecting throttle valve control unit -J338- → Chapter. |
|
|
Reading measured value block 5 -> | 780/min 99 % 0 km/h Idling |
|