skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing radiator

Octavia Mk1

Removing and installing coolant pump
Removing and installing coolant pump
Special tools and workshop equipment required
t  Supporting device - MP 9-200-
t  Catch pan, e.g. -V.A.G 1306-
t  Torque wrench e.g. -V.A.G 1331 -(5...50 Nm)
t  Torque wrench e.g. -V.A.G 1332 -(40...200 Nm)
  Note
Always replace seals and gasket rings.
Removing
–  Drain coolant → Chapter.
–  Remove main drive toothed belt → Chapter.
   
–  Remove guide pulley -6-; to this end release the fixing screw -5- of the guide pulley.
–  Unscrew the fixing screw -1- of the toothed belt guard at rear.
–  Unscrew the fixing screws -4- of the coolant pump and remove the toothed belt guard at rear -2- and the coolant pump -3-.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–  Position the coolant pump -3- in the cylinder block and tighten the fixing screws -4- (20 Nm).
–  Install guide pulley -6- and tighten the fixing screw -5- (25 Nm).
–  Filling system with coolant → Chapter.
  N19-0295
–  Remove guide pulley -6-; to this end release the fixing screw -5- of the guide pulley.
–  Unscrew the fixing screw -1- of the toothed belt guard at rear.
–  Unscrew the fixing screws -4- of the coolant pump and remove the toothed belt guard at rear -2- and the coolant pump -3-.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–  Position the coolant pump -3- in the cylinder block and tighten the fixing screws -4- (20 Nm).
–  Install guide pulley -6- and tighten the fixing screw -5- (25 Nm).
–  Filling system with coolant → Chapter.
  N19-0295

Fuel supply, gas operation > < Removing and installing radiator