Octavia Mk1
Note
|
1 - | Timing belt guard - top part |
2 - | Timing belt |
q | check for wear |
q | do not kink |
q | removing and installing, tensioning → Chapter |
3 - | 20 Nm + torque a further 1/4 turn (90°) |
q | replace |
4 - | Camshaft sprocket |
q | take note of the position when installing the timing belt → Chapter |
5 - | 10 Nm |
q | coat with -D 000 600 A2- |
6 - | Rear timing belt guard |
7 - | 5 Nm + torque a further 1/4 turn (90°) |
q | replace |
8 - | Seal |
q | replace |
9 - | Cap |
q | Replace seal if damaged |
10 - | Cylinder head cover |
11 - | Gasket for cylinder head cover |
q | replace if damaged |
q | before fitting, coat contact faces of bearing cover/cylinder head cover -D 454 300 A2-. |
12 - | Cylinder head bolt |
q | replace |
q | sequence for slackening and tightening → Anchor |
13 - | Cylinder head |
q | check for distortion → Fig. |
q | installing → Anchor |
q | after replacing fill entire system with fresh coolant |
14 - | Cylinder head gasket |
q | replace |
q | metal gasket |
15 - | 20 Nm |
16 - | Tensioning pulley |
q | Tensioning toothed belt → Chapter |
17 - | 20 Nm |
18 - | Belt pulley |
19 - | V-ribbed belt |
q | before removing mark running direction |
q | removing and installing → Chapter |
20 - | Timing belt guard - bottom part |
|