| Removing and installing parts of the exhaust system |
Note | t
| Always replace gaskets and self-locking nuts. |
| t
| When performing installation work on the exhaust system, make sure the exhaust system is not mounted under tension and has adequate clearance from the vehicle body. If necessary slacken the clamping sleeves and collar clamp and align the silencer and exhaust pipe so as to create adequate clearance between these components and the vehicle body, and that the weight of the exhaust system is evenly distributed over the hangers. |
| t
| Use a screwdriver to slacken and tighten the clamps of the heat shield. Tightening torque: 2 Nm |
|
|
|
