skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pan > < Removing and installing parts of the lubrication system

Octavia Mk1

Disassembling and assembling oil filter holder
Disassembling and assembling oil filter holder
1 - Screw plug
2 - Gasket ring
3 - Spring
–  for overpressure valve approx. 0.4 MPa
4 - Piston
–  for pressure relief valve
5 - Gasket
–  replace
6 - Oil retaining valve
–  Tightening torque 8 Nm
–  integrated into the oil filter holder
7 - Gasket ring
–  push on as far as collar of connecting tube -pos. 8-
8 - Cap
9 - Retaining clip
10 - Screw plug, 15 Nm
11 - Gasket ring
–  cut open if leaking and replace
12 - 0.14 MPa oil pressure switch -F1-, 25 Nm
–  black
–  check → Chapter
13 - Gasket ring
–  cut open if leaking and replace
14 - Oil filter holder
15 - 15 Nm + torque a further 1/4 turn (90°)
–  replace
16 - Gasket
–  replace
–  Insert into lugs on oil cooler
17 - Oil cooler
–  ensure clearance to surrounding components
–  pay attention to the notes → Chapter
18 - 25 Nm
19 - Oil filter
–  slacken with tensioning strap
–  tighten by hand
–  pay attention to installation instructions on oil filter
  S17-0015

Removing and installing oil pan > < Removing and installing parts of the lubrication system