skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing components and functions > < Replacing engine control unit

Octavia Mk1

Adapt the engine control unit to the electronic immobiliser
Adapt the engine control unit to the electronic immobiliser
Special tools and workshop equipment required
t  Vehicle system tester -V.A.G 1552 - with cable -V.A.G 1551/3-
Test condition
l  Authorised car key available
–  Connect vehicle system tester -V.A.G 1552- with cable -V.A.G 1551/3 -.
–  Switch on ignition.
–  Enter 17 for the address word “dash panel insert” and confirm the entry with Q.
   
At the display is shown e.g°:
–  Press → key.
  
1U1919034J A+-COMBIINSTR.VDO X27     -> 
Coding 02142                   WSC  xxxxx
At the display is shown e.g°:
–  Press → key.
  
IMMO-IDENT NO: SK27Z0W0095705          ->

      

      

    
      

      

    
The following appears in the display:
– 
          Enter 10 for the function “Adaptation” and confirm with Q.

      		 
      
    
Vehicle system test               HELP
Select function XX

      

      

    
      

      

    
The following appears in the display:
– 
          Enter 00 and confirm with the Q key.

      		 
      
    
Adjustment
Enter channel number XX

      

      

    
      

      

    
The following appears in the display:
– 
          Confirm the entry with the key Q.

      		 
      
    
Adaptation                             Q
Erase initialisation values?

      

      

    
      

      

    
The following appears in the display:
– 
          End adaptation by pressing the → key.
 
      Note
When the ignition is switched on again the engine control unit identification is read by the immobilizer control unit.

      		 
      
    
Adaptation                            ->
Initialisation values erased

      

      

    


Testing components and functions >
< Replacing engine control unit