Octavia Mk1
| Disassembling and assembling coolant distributor housing |
| 1 - | Gasket ring |
| q | replace |
| 2 - | Retaining clip |
| q | check tightness |
| 3 - | 10 Nm |
| 4 - | O-ring |
| q | replace |
| 5 - | Sender for the coolant temperature -G62 - |
| q | with coolant temperature gauge sensor -G2- |
| q | contacts gold-plated |
| q | for engine control unit |
| q | before removing, reduce pressure in cooling system if necessary |
| q | test → 1.6 l/75 kW Engine, Fuel Injection and Ignition System; Rep. Gr.01 |
| 6 - | Connector |
| 7 - | Heating resistor connection |
| q | 14…16 Ω at 25 °C |
| 8 - | 10 Nm |
| 9 - | Thermostat for map-controlled engine cooling -F265- |
| q | with connection fitting |
| q | check → Chapter |
| – | Start of opening approx. 105 °C |
| – | opening stroke at least 7 mm |
| 10 - | Gasket ring |
| q | replace |
| 11 - | Coolant distributor housing |
| q | depending on version with connection for ATF cooler |