Octavia Mk1
Parts of the cooling system fitted to body |
Note
t | When the engine is warm the cooling system is under pressure. If necessary reduce pressure before repairs. |
t | The hose connections are secured with spring-type clips. In the event of repairs only use spring-type clips. |
t | Use pliers for spring strap clips to fit the spring strap clips. |
t | Always replace seals and gasket rings. |
t | When installing fit the coolant hoses free of stress, without them touching any other components (pay attention to the marking on the coolant connection). |
t | Draining and filling system with coolant → Chapter |
t | Information concerning the mixture ratios → Chapter |
t | Inspecting cooling system for leaks → 1.6 litre/74 kW Engine, Mechanical Components; Rep. Gr.19. |
1 - | Radiator |
q | removing and installing → Chapter |
q | after replacing fill entire system with fresh coolant |
2 - | O-ring |
q | replace |
3 - | Top coolant hose |
q | attached to radiator by retaining clips |
q | connection diagram for coolant hoses → Chapter |
4 - | Air duct scoop |
5 - | 10 Nm |
6 - | Auxiliary fan |
q | on vehicles with air conditioning |
7 - | The fan ring |
8 - | Retaining clip |
q | check tightness |
9 - | Connector |
10 - | Radiator fan -V7- |
11 - | To coolant pipe |
q | connection diagram for coolant hoses → Chapter |
12 - | Expansion bottle |
q | Inspecting cooling system for leaks → 1.6 litre/74 kW Engine, Mechanical Components; Rep. Gr.19 |
q | Test pressure 0.14...0.16 MPa (1.4 ...1.6 bar) - overpressure |
13 - | Cap |
14 - | Support |
q | for fan connector |
15 - | Bottom coolant hose |
q | attached to radiator by retaining clips |
q | connection diagram for coolant hoses → Chapter |
16 - | O-ring |
q | replace |
17 - | Coolant temperature sensor radiator outlet -G83-, 35 Nm |
q | check → Chapter |
q | pay attention to different version |
18 - | Support |
q | for radiator |
q | Check fitting position |
19 - | 10 Nm |