Octavia Mk1
Removing and installing sealing flange and pressure plate |
Note
t | Repairs to clutch → 5-Speed Manual Gearbox 02K; Rep. Gr.30. |
t | Secure the engine with engine mount -MP 1-202- and distance sleeves -T30010- on the assembly stand before performing assembly work. |
1 - | 15 Nm |
2 - | Gasket ring |
q | do not oil sealing lip of gasket ring |
q | replace → Chapter |
3 - | Front sealing flange |
q | must be positioned on dowel sleeves |
q | removing and installing → Chapter |
q | remove oil pan for removing and installing |
4 - | Threaded pin, 10 Nm |
q | replace |
q | unscrew for attaching engine holder -T10012- |
5 - | Cylinder block |
q | removing and installing crankshaft → Chapter 13-4 |
q | disassembling and assembling pistons and conrod → Chapter 13-5 |
6 - | Gasket ring |
q | replace |
7 - | 100 Nm |
8 - | 60 Nm + torque a further 90° (1/4 turn) |
q | replace |
9 - | Washer |
q | Check fitting position |
10 - | Pressure plate/driver disc |
q | remove and install flywheel and pressure plate → 5-Speed Manual Gearbox 02K; Rep. Gr.30 |
q | removing and installing drive plate → Chapter |
11 - | Intermediate plate |
q | hang on the sealing flange → Fig. |
q | must be positioned on dowel sleeves |
q | do not damage/bend during assembly work |
12 - | Rear sealing flange with gasket ring |
q | must be replaced completely |
q | use supporting sleeve supplied for installing |
q | remove oil pan for removing and installing |
q | Neither grease nor oil sealing lip of sealing ring |
q | before installing remove grease residue from crankshaft journal with a clean cloth |
q | supporting sleeve must not be removed until after pushing sealing flange onto the crankshaft journal |
|