Skoda Workshop Service and Repair Manuals

Replacing inlet camshaft seal Removing –  Remove V-ribbed belt → Chapter.

–  Disconnect the plug from the Hall sender -G40--arrow-. –  Remove top toothed belt guard. –  Remove the housing for the hall sender. –  Remove the washer and trim for the hall sender.

–  Tighten screw -MP 1-215/1 - by hand fully up to the stop in the crankshaft to the guide the gasket ring extractor. –  Unscrew inner part of the gasket ring extractor -MP 1-215- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.

–  Oil the thread head of the gasket ring extractor -MP 1-215-, position and forcely screw into the gasket ring as far as possible. –  Slacken knurled screw and turn inner part of seal extractor against the camshaft until the seal is pulled out. Install elastomer gasket ring –  Lightly oil the sealing lip of the gasket ring.

–  Insert insertion sleeve -MP 1-228/2- on the camshaft stub. –  Slide gasket ring over the insertion sleeve.

–  Press in gasket ring with insertion sleeve -MP 1-228/1 - up to the stop. Use screw -MP 1-228/3-. Install PTFE gasket ring   Note Do not oil sealing lips of the gasket ring. –  Remove oil residue on the camshaft stud with a clean cloth.

–  Insert sleeve -T10071/5- on the camshaft stub. –  Position gasket ring above sleeve onto the camshaft stub and remove sleeve.

–  Press in the gasket ring with pressure bushing -T10071/3- and screw M8x60 up to the stop. Proceed as follows for both versions –  Place the cover for the hall sender with the notch in the inlet camshaft. –  Install the disc (with the cone pointing outwards) and tighten up with the fixing screw to 25 Nm. –  Install the housing for the hall sender and tighten up to 10 Nm. –  Install top toothed belt guard. –  Plug in the plug connector for the hall sender. –  Install the V-ribbed belt → Chapter.