Octavia Mk1
Note
|
1 - | 15 Nm |
2 - | 15 Nm |
3 - | Bracket at top |
q | for cable of oil level and oil temperature sender -G266 - |
4 - | Sprocket |
5 - | Dipstick |
q | oil level must not exceed max. marking |
6 - | Filler funnel |
q | Remove for extracting oil |
7 - | Guide tube |
8 - | Oil injection nozzle |
q | for piston cooling |
9 - | 25 Nm |
q | replace without sealant |
10 - | O-ring |
q | replace |
11 - | Intake manifold |
q | Clean strainer if dirty |
12 - | Baffle |
13 - | Oil pan |
– | removing and installing → Chapter |
14 - | Drain plug, 30 Nm |
q | with integrated gasket ring |
q | replace |
15 - | 10 Nm |
16 - | Oil level and oil temperature sender -G266- |
q | only for vehicles with service interval extension |
q | test → Electrical System; Rep. Gr.90 |
17 - | Sealing ring |
q | replace |
18 - | Oil pump |
q | with pressure relief valve 1.2 MPa (12 bar) |
q | before installing, check whether both dowel sleeves for centering the oil pump/cylinder block are inserted |
q | if there is any scoring on contact surfaces and gears, replace |
q | Tighening torque of oil pump cover at oil pump housing: 10 Nm |
19 - | Oil pump sprocket |
q | Check fitting position |
q | Fits onto oil pump shaft in one position only |
20 - | Bracket at bottom |
q | for cable of oil level and oil temperature sender -G266 - |
21 - | 15 Nm |
22 - | 25 Nm |
q | replace |
23 - | Oil pump chain |
q | before removing mark running direction |
q | check for wear |
24 - | Sealing flange on the belt pulley side |
q | removing and installing → Chapter |
q | Replace crankshaft seal on belt pulley side → Chapter |
q | install with silicone sealant -D 176 404 A2- |
25 - | Chain tensioner, 15 Nm |
q | do not disassemble |
q | Replace chain tensioner if spring is broken. |
q | Check fitting position |
q | When installing, hook on the spring and pretension |