–
| Disconnect plug -1- from Coolant temperature sender-G62--2-. |
Note By disconnecting the plug from the coolant temperature sender, engine condition “cold” is simulated and when the ignition is switched on a corresponding preheating process is performed. |
–
| Unplug connector of the glow plugs. |
–
| Connect Hand multimeter for voltage measurement between glow plug connector and engine mass. |
–
| Switch on ignition. The approx. battery voltage must be displayed for approximately 20 seconds. |
If no voltage is present: |
During the simulated preheating process the glow period warning lamp -K29- must light up. |
If the warning lamp does not light up: |
|
|
|