Removing and installing parts of the lubrication system |
Note t
| If considerable quantities of metal swarf or abrasion is found in the engine oil when carrying out engine repairs, carefully clean the oil galleries in order to avoid consequential damage and additionally replace the oil cooler. |
t
| The engine oil level must never exceed the max. marking - risk of damage to catalytic converter! |
t
| Remove filler funnel on oil dipstick guide tube for extracting oil. |
Check the engine oil, amount of oil, oil specification: → Octavia |
–
| Duocentric pump with pressure relief valve 1.2 MPa (12 bar) |
–
| Before installing, check whether both dowel sleeves for centering oil pump/cylinder block are present |
–
| if there is any scoring on contact surfaces and gears, replace |
–
| Tighening torque of oil pump cover at oil pump housing: 10 Nm |
–
| Fits onto oil pump shaft in one position only |
–
| before removing mark running direction |
–
| replace the gasket ring for the crankshaft → Chapter |
–
| Clean strainer if dirty |
18 - | Oil level and oil temperature sender -G266- |
–
| only for vehicles with service interval extension |
21 - | Oil drain plug, 30 Nm |
|
|
|