skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pan > < Removing and installing parts of the lubrication system

Octavia Mk1

Disassembling and assembling oil filter holder
   
Disassembling and assembling oil filter holder
1 - Screw plug, 25 Nm
2 - Gasket
–  replace
3 - Oil cooler
–  ensure clearance to surrounding components
4 - Gasket
–  replace
–  Insert into lugs on oil cooler
5 - Gasket ring
–  cut open if leaking and replace
6 - Oil pressure switch 0,09 MPa -F1-, 25 Nm
–  grey
7 - Screw plug
–  must not be opened
8 - Gasket ring
9 - Spring
–  for pressure relief valve 0.5 MPa
10 - Piston
–  for pressure relief valve
11 - Screw plug, 10 Nm
12 - Gasket ring
–  cut open if leaking and replace
13 - Gasket
–  replace
14 - 15 Nm + torque a further (90°) 1/4 turn
–  replace
15 - Oil filter holder
16 - Gasket ring
–  replace
17 - Hollow screw, 20 Nm
18 - Cap, 25 Nm
–  slacken and tighten with oil filter wrench -SW 36-
19 - O-ring
–  replace
20 - O-ring
–  replace
21 - Oil filter element
–  pull off from cap -Pos. 18- → Anchor
–  in case of oil filter change, replace O-rings -Pos. 19- → Anchor and -Pos. 20- → Anchor
  S17-0023

Removing and installing oil pan > < Removing and installing parts of the lubrication system